Transitional Pull, 5-1/16" Center-to-Center, Brushed Nickel New Dot point is for cutting

Dot point is for cutting plastic materials used for stencils

Its 3/8" width gives you a perfect balance of stability for straight cuts and maneuverability for gentle curves

and functionality make up this hand hammered copper round mirror with hand forged rivets

Streamline drilling and counterboring with pre-determined counterbore depths and screw choices in materials up to 1" thick

With the Powermatic PM2000 table saw

Transitional Pull, 5-1/16" Center-to-Center, Brushed Nickel New Dot point is for cuttingFrom Richelieu Hardware, the subtle contrast of curved lines on the handle and flared square feet will enhance furniture and cabinetry with a touch of sophistication. Specifications Center to Center measurement (distance between the drill holes): 5 1 16" (128 mm) Length (from left to right): 5 19 32" (142 mm) Width (top to bottom): 9 16" (14 mm) Projection (front to back): 1 11 32" (34 mm) Finish: Brushed Nickel, made of metal Mounting hardware is